Spoiler alert! This is the second to the last post covering the construction of my Barton Tudor. Yes, I've named it the "Barton Tudor" as it will house my English Barton Tudor 3/4 scale furniture. Just seemed the thing to do!
The roof goes on...
INSTALLATION DEVIATION: the roof installation. The roof panels were shingled first, then are installed to the home.
The roof pieces are glued and nailed on to the back body peaks where I left openings in the rows of shingles. The front roof pieces are glued and clamped, I didn't want to nail them to the front peak for fear I would break the peak off.
After gluing the top ridge to the top of the roof I finish gluing the last row of shingles on the installed roof, butting them up to the top ridge. I also shingle the roof openings I left open for nailing to the home's peak.
Here I'm gluing and clamping the decorative trim to the front roof edges. I have used scrap trim underneath these new "eaves" to achieve the spacing between the peak and the eave trim and to insure the eave trim is square to the edges.
Hinging the Door Wall...
INSTRUCTION DEVIATION: I pitched the hinges and clasps of the kit's, bought more decorative hinges and clasps and added an extra hinge as well. I also purchased little screws to attach the hinges.
|I bent the tip of one side of each hinge so it curled around the trim on the outside edge of the home.|
Well, I'm sorry, I was bad, I didn't take any picts of gluing the feet on, the hinge placement and the drilling of their holes and screwing in their wee screws.
For the Door Wall attachment, I put the home on its back, set the Door Wall on, making sure to adjust it to fit properly and had at it! I did make sure the three hinges were space evenly to each other.
I then cut some trim and trimmed out the sides of the home and polyed the whole thing, even the shingles.